產品中心
您的位置：網站首頁 > 產品中心 > 電子式互感器
電子式電流互感器
名稱：電子式電流互感器
型號：LEZZBJH8-10B
LEZZBJH8-10B型電子式電流互感器
LEZZBJH8-10B electronic current transformer
一、概述(Description)
本型電子式電流互感器為環氧樹脂澆注絕緣全封閉支柱式產品，適用于額定頻率50Hz或60Hz、額定電壓10kV的電力系統中，作電能計量、電流測量和繼電保護用。本產品符合IEC60044-8：2002及GB/T20840·8-2007《電子式電流互感器》標準。
The electronic current transformer is casting resin insulated, fully enclosed and post type product. It is used for metering electric energy and current, relay protection in the electrical system up to rated frequency 50Hz or 60Hz and rated voltage 10kV. The transformer can be executed according to the standards IEC60044-8：2002 and GB/T20840·8-2007.
三、結構簡介(Construction)
本型電子式電流互感器為環氧樹脂澆注絕緣全封閉支柱式結構，耐污染及潮濕，適宜于任何位置、任意方向安裝。測量范圍寬，二次開路不會產生高電壓，二次輸出為小電壓信號，功耗極小，不需將大信號轉化為小信號，簡化了誤差源，提高了整個系統的穩定性和準確度。
This electronic current transformer is casting resin insulated, fully enclosed and post type product. It is fouling resistance and moisture protection, and can be erected at any position and direction. This transformer has wide measurement scope, the secondary open circuit does not produce high voltage and the secondary output is the signal of low voltage. The power consumption is very small. As there is no need to transfer the signal of high voltage to the signal of low voltage, the source of error is simplified and the stability and order of accuracy of the whole system are improved.
四、技術參數(Technical data)
1、額定絕緣水平(rated insulation level)：12/42/75kV
2、局部放電水平符合GB/T20840·8-2007《電子式電流互感器》標準。(The conditions of the partial discharge test according to GB/T20840·8-2007《electronic current transformer》will be fulfilled without exception.)
3、此互感器二次繞組可生產單繞組、雙繞組、三繞組、四繞組。(The secondary windings of this transformer can produce single winding, double winding, three windings and four windings.)
4、用戶如有其它技術要求，可與我廠聯系。(If the customer has other requirement for technology, they can contact our factory.)
5、技術參數表(technical data form)：
表1：額定一次電流及動熱穩定電流(Rated primary current , rated dynamic and thermal current)
表2：常規技術參數(Common technical parameters)
|
1 |
設備最高電壓
Highest voltage of equipment |
12kV |
|
2 |
額定一次電流
Rated primary current |
20～1250A |
|
3 |
額定二次電壓（測量級）
Rated secondary voltage for measurement |
1.5V，4V |
|
4 |
額定二次電壓（保護級）
Rated secondary voltage for protection |
150mV(空心線圈)
150mV(air-core coil) |
|
5 |
額定二次電壓（保護級）
Rated secondary voltage for protection |
225mV(鐵心式線圈)
225mV(core type coil) |
|
6 |
額定輸出數字量（測量級）
Rated digital output for measurement |
0x2D41 |
|
7 |
額定輸出數字量（保護級）Rated digital output for protection |
0x01CF/0x00E7 |
|
8 |
測量級準確級
Accuracy class for measurement |
0.2，0.2S級(class) |
|
9 |
保護級準確級
Accuracy class for protection |
5TPE(空心線圈)
5TPE(air-core coil) |
|
10 |
保護級準確級
Accuracy class for protection |
5P25(鐵心式線圈)
5P25(core type coil) |
|
11 |
額定頻率
Rated frequency |
50Hz（或60Hz） |
|
12 |
額定負荷
Rated burden |
2kΩ，20kΩ,2MΩ |
|
13 |
暫態特性的額定對稱
短路電流倍數
Rated symmetrical short-circuit-current factor for transient performance |
25 |
|
14 |
額定一次時間常數
Rated primary time constant |
100mS |
|
15 |
額定喚醒時間
Rated wake-up time |
0 |
|
16 |
環境溫度
Ambient temperature |
－40℃～＋40℃ |
|
17 |
環境污穢等級
Pollution class |
Ⅱ |
五、外形及安裝尺寸圖(Outline drawing and dimensions of installation)
